Power Supply Products
|
| 150 Watt DC-DC Power Converter |
150 Watt DC-DC Power Converter |
The picoPSU-150-XT is a
compact high efficiency DC-DC converter that plugs directly into a 24-pin ATX MB connector.
It features a built-in P4 power cable for the motherboard and a
4-pin Molex and SATA power connector for drives and accessories.
- Over 96% efficiency
- 24 pin ATX connector
- 12 volts DC input
- 150 watts output
- 8A @ 12V
- 6A @ 3.3V
- 6A @ 5V
- MTBF = 100,000 hours at 55C deg.
|
|
$49.50 each |
|
| 150 Watt 12 Volt AC Power Adapter |
150 Watt 12 Volt AC Power Adapter
Adapter Cable for 150w DC converter |
Fanless
AC-DC power adapter. No overload fan or vent slots in sealed housing.
150 Watts output is the perfect match for the 150 watt DC-DC
converter.
- 100-240 VAC input
- 12 Volts Output
- 12.5 Amps, 150 watts output
- 160 watt peak
- 4 pin mini-din jack connector
- Adapter cable for 150w DC converter included
$44.50 each
|
|
| PS-150-XT Extension Cable |
150 Watt PS with Extension Cable installed |
| This cable is used to add extra drive power connectors
to the 150 Watt DC-DC Power Converter above.
One end has a special connector to fit the extra header on the power
supply, the other end has
a standard SATA power connector and 4-pin Molex power connector.
$3.00
|
|
| 200 Watt 6-pin P4 DC-DC Power Converter |
200 Watt 6-pin P4 DC-DC Power Converter
|
| Internal 200 watt DC-DC power converter provides power
to the system. Use this power converter when installing the DG45FC
motherboard or other MB's with a P4 connector.
Features extended four wire 6-pin power input cable and 12 volt
4-pin P4 power output
cable. Limited to 120w output when using the High Performance 12 Volt AC Power Adapter
below. The benefits of using this power converter is that the
power supply mounted on the side of the MB instead of right next to
the memory chips where heat can build up. It also runs cooler and has
a built-in P4 cable.
Note: Power input cable is modified for a 6-pin connector
to use with our heavy-duty AC power adapter below.
- 12 volts input
- 200 watts output rating
- 12A @ 12V
- 6A @ 3.3V
- 6A @ 5V
$79.95 each
|
|
| High Performance 12 Volt AC Power Adapter |
High Performance 12 Volt AC Power Adapter |
High Performance AC power adapter. Totally fanless
with no overload fan or vent slots, completely sealed housing. High
efficiency design allows adapter to remain cool under load. 15 Amp
peak load rating starts up power hungry hard drives.
- 90 to 264 VAC input
- 12 Volts Output
- 120 Watts (rated)
- 9 Amps Continuous, 15 Amp Peak
- 6-pin Connector
$105.00 each
|
|
| 120 Watt DC-DC Power Converter |
120 Watt DC-DC Power Supply |
The picoPSU-120 is the smallest snap-in 12V ATX dc-dc
power supply. Plugs directly into a 20-pin ATX MB connector. 120 watts
maximum output. 95% efficiency. To operate, an external AC power adapter is required,
see below. Use this power supply in the
Mass Storage MS4x Case.
- 12 volts input
- 120 watts output
- 7A @ 12V
- 6A @ 3.3V
- 6A @ 5V
- 5mm x 2.5mm connector
$49.95 each
|
|
|
Standard 12 Volt AC Power Adapter |
Standard 12 Volt AC Power Adapter |
External AC power adapter for use with the 120 watt
DC-DC converter above.
Use this AC power adapter with the Mass Storage
MS4x Case.
- 100 to 240 VAC input
- 12 Volts Output
- 8.5 Amps
- 5mm x 2.5mm Connector
$39.00 each
|
|
| 2U External Power Supply Block-off Plate |
 |
| This block-off plate fits the 2U power supply opening
on the rear panel of the 3000 case. It will allow you to run a
external low-voltage power supply similar to a notebook computer.
The plate features steel threaded inserts and a power socket
cut-out. $15.00
|
|
